side bar
Stacks Image 428
Stacks Image 432

Discrete Wire Low voltage interface


  NX Tester Test Point Boards are divided into two sets of 64 points, each designed to mate with a 64 pin card edge connector. Dynalab uses card edge connections, rather than fine pitch, pin-type connectors, for durability and ease of use. A wide range of interface cables are offered to attach a Dynalab NX Tester to your test fixture.



Stacks Image 430
Discrete Wire Interface Cable

  The Discrete Wire Interface Cable is the most commonly used interface cable. Its 64 individual 24 AWG wires are cut to length - ready to be attached to a fixture. This cable interfaces any Dynalab Tester and is available in three lengths.


5-2006......6’ Interface cable assembly
5-2012......12’ Interface cable assembly
5-2018......18’ Interface cable assembly



Stacks Image 416
Discrete Wire Connector

  To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable. Note: Special crimping is required to attach wires to this connector.

5-2091......Card Edge Connector



Stacks Image 414

Hipot Fixture Interfacing


  NX Hipot Test Point Boards are divided into two sets of 32 points, each designed to mate with a 32 pin DIN connector.



Stacks Image 412
Hipot Discrete Wire Interface Cable

  The Hipot Discrete Wire Interface Cable consists of 32 individual 22 AWG wires are cut to length - ready to be attached to a fixture.

5-2106......Discrete Wire Interface 6’



Stacks Image 410
Hipot Discrete Wire Connector

  To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable.

5-2093......HIPOT Mating Connector w/ Hood
5-2092......HIPOT Mating Connector w/O Hood



Stacks Image 408
Terminal Block

  To aid test fixture building and maintenance, Dynalab offers test point distribution solutions. Ribbon cables neatly deliver test points from the NX Tester to Terminal Block Interfaces. Fixture elements are attached to the Terminal Block Interface by screw terminals. Should a fixture block require maintenance, it can be unscrewed and replaced with a substitute in seconds.



Stacks Image 406
Terminal Block Interface

  The Terminal Block Interface allows the user to distribute the test points away from the NX Tester and provide an easy to use screw terminal interface. These devices are connected to the NX Tester using the Ribbon Cable Interface Assemblies.

5-2191......Terminal Block Interface



Stacks Image 404
Ribbon Interface Cable

  The Ribbon Interface Cable is offered for specialised applications where a Dynalab NX Tester must be connected to a printed circuit board or any device containing a dual row header (0.100" spacing). This cable is available in three lengths.
5-2102......Ribbon Interface Cable 2’
5-2104......Ribbon Interface Cable 4’
5-2108......Ribbon Interface Cable 8’



Stacks Image 402
Ribbon Cable Components


  To create custom ribbon cables, Dynalab offers 64 conductor ribbon cable and two common ribbon cable connectors. Both connectors are insulation displacement.

5-2192......Card Edge Connector
5-2193......Dual Row Header Connector
5-2194......64 Conductor Ribbon Cable (100 foot lengths)